Hp laserJet Pro M402, M403 User Guide enww

NOTE:
If the tray is not adjusted correctly, an 
error message might display during printing or 
the paper might jam.
2
5.
Slide the tray completely into the printer.
ETT-PAC
KARD
1
2
6.
At the computer, begin the printing process from 
the software application. Make sure that the 
driver is set to the correct paper type and size for 
the paper being printed from the tray.
ENWW
Load Tray 2
19

---

Tray 2 paper orientation
When using paper that requires a specific orientation, load it according to the information in the following 
table.
Paper type
Output
How to load paper
Letterhead or preprinted
1-sided printing
Face-up
Top edge at the front of the tray
123
1
2
Letterhead or preprinted
2-sided printing
Face-down
Top edge at the front of the tray
123
1
2
20
Chapter 2 Paper trays
ENWW

---

Load Tray 3
Introduction
The following information describes how to load paper in Tray 3. This tray holds up to 550 sheets of 75 g/m
2 
(20 lb) paper.
CAUTION:
Do not print envelopes, labels, or unsupported sizes of paper from Tray 3. Print these types of 
paper only from Tray 1.
1.
Pull the tray out and lift up slightly to remove it 
completely from the printer.
NOTE:
Do not open the tray while it is in use.
RD
1
2
3
2.
Adjust the paper-width guides by squeezing the 
adjustment latch on the left guide and sliding the 
guides to the size of the paper being used.