Hp laserJet Pro M402, M403 User Guide enww

Load Tray 1
Introduction
The following information describes how to load paper in Tray 1. This tray holds up to 100 sheets of 75 g/m
2 
(20 lb) paper.
CAUTION:
To avoid paper jams, never add or remove paper from Tray 1 during printing.
1.
Open Tray 1 by grasping the handles on the left 
and right side of the tray and pulling down.
HEWLET
T-PACKARD
2
2.
Slide out the tray extension.
HEWLET
T-PACKARD
2
14
Chapter 2 Paper trays
ENWW

---

3.
For long paper, flip out the tray extension to 
support the paper.
HEWLET
T-PACKARD
2
4.
Press down on the tab on the right paper guide, 
and then spread the paper guides to the correct 
size.
HEWLET
T-PACKARD
2
5.
Load the paper into the tray. Make sure that the 
paper fits under the tabs and below the 
maximum-height indicators.
The orientation of the paper in the tray varies 
depending on the paper size. For additional 
information, see 
Tray 1 paper orientation 
on page 17
HEWLET
T-PACKARD
2
ENWW
Load Tray 1
15

---

6.
Press down on the tab on the right paper guide, 
and then adjust the paper guides so that they 
lightly touch the paper stack but do not bend the 
paper.
HEWLET
T-PACKARD
2
7.
At the computer, begin the printing process from 
the software application. Make sure that the 
driver is set to the correct paper type and size for 
the paper being printed from the tray.
16
Chapter 2 Paper trays
ENWW

---