Ccna certification Practice Tests

D. 

Router(config-if)#sdm routing

 140.  You have configured a ROAS and set up the switch to connect to the router. However, you 

cannot route between VLANs. Which command would you use on the switch to verify 

operations?

A. 

Switch#show ip route

B. 

Switch#show interface status

C. 

Switch#show interface trunk

D. 

Switch#show switchport

---

114

 

Chapter 3 

■

  IP Connectivity (Domain 3)

 141.  When configuring a router in a ROAS configuration, which command will enable the 

interface to accept frames tagged for VLAN 10?

A. 

Switch(config-subif)#encapsulation vlan 10 dot1q

B. 

Switch(config-if)#interface Fa 0/0.10

C. 

Switch(config-subif)#encapsulation dot1q 10

D. 

Switch(config-subif)#ip address 192.168.10.1 255.255.255.0

 142.  Which statement is correct about ARP in relation to ROAS?

A.  Each physical interface has a unique MAC address, which responds to ARP requests.

B.  Each subinterface has a unique MAC address, which responds to ARP requests.

C.  Each IP address has a unique MAC address, which responds to ARP requests.