Basic Configuration Commands Table of Contents

Parameter

Parameter	Description
no	Number of the telnet session that is displayed after the show telnet command is run

Default

None

Command mode

Management mode

Instruction

The command is used to clear the telnet session at the server.

Example

clear telnet 1
The telnet session whose sequence number is 1 is cleared at the server.

2.1.8 show telnet

The following is a command format to display the telnet session at the server:
show telnet

Parameter

None

Default

None

Command mode

All command modes except the user mode

Instruction

The command is used to display the telnet session at the server. The displayed information includes the sequence number, peer address, peer port, local address and local port.

Example

Switch# show telnet
If you run the previous command, the result is shown as follows:
NO. Remote Addr Remote Port Local Addr Local Port
1 192.168.20.220 1097 192.168.20.240 23
2 192.168.20.180 14034 192.168.20.240 23

2.1.9 debug telnet

The following is a format of the debug command for the telnet session:
debug telnet

Parameter

None

Default

None

Command mode

Management mode

Instruction

The command is used to open the switch of the telnet debug.
If the switch of the telnet debug is opened, the negotiation processes of all the incoming telnet sessions are printed on the window that the debug command invokes. The debug telnet command is different from the telnet debug command. The former is to export the debug information of the telnet session connected to the server. The latter is to export the debug information of the telnet session that the client originates.