Lesson 1
Write about fault diagnosis and gif solutions for them. .
Blank Screens is the second full-length release from Vermont band The Static Age. It was released on September 16th, 2006 via ReIgnition Recordings and was produced by Michael Birnbaum and Chris Bittner.
Installation problems Installation (or setup) of a computer program (including device drivers and plugins), is the act of making the program ready for execution. Installation refers to the particular configuration of a software or hardware with a view to making it usable with the computer.
Drive fragmentation In the maintenance of file systems, defragmentation is a process that reduces the degree of fragmentation. It does this by physically organizing the contents of the mass storage device used to store files into the smallest number of contiguous regions (fragments, extents). It also attempts to create larger regions of free space using compaction to impede the return of fragmentation.
Unplugged or disconnected from the power source is that disconnect is to sever or interrupt a connection while unplug is to disconnect from a supply, especially an electrical socket. As a noun disconnect. is a break or interruption in an existing connection, continuum, or process; disconnection. Other Comparisons: What's the difference? Disconnect vs Unpluge.
Lesson 2
Look at the meanings of these progamming instructions. Ask and answer questions about how each of the instructions controls information. Use make and cause.
Cout: sends out information to the screen
Cin: takes input from the keyboard
Rename: changes a filename
Exit: stops a program
Time: returns the number of seconds since midnight on 1 January 1970
Remove: deletes a file
A : Which instruction makes the computer show something on the screen?
B: “Cout”.
A : Which instruction takes input from the keyboard
B: “Cin”.
A : Which instruction changes a filename?
B: rename
A : Which instruction stops a program?
B: time
A : Which instruction deletes a file?
B: remove
Lesson 3
Answer the questions from the task above.
What is a multimeter used for?
What is the cable tester used for?
What is a system diagnostic card used for?
What is the diagnostic software used for?
1. A multimeter is used for measuring two or more electrical values — voltage (volts), current (amps) and resistance (ohms).
2. The cable tester is used for the verification of the electrical connections in a signal cable or other wired assembly.
3. A system diagnostic card is used to discover and report errors found in the motherboard of a computer.
4.The diagnostic software is used for identifying problems on a computer or piece of equipment. This software tests the onboard systems for malfunctioning and helps to alert users of potential problems or breakdowns.
Leson 4
Write a short report to the IT supervisor on the most serious incident. You will need to give recommendations on how to deal with the incident.
“On Friday afternoon, February 3, 2019, at 2 p.m. in ABC Shipping Co. located in 13th Avenue, Applewood, one of the warehouse workers (John Keegan) slipped and fell while carrying heavy (85 lbs) inventory. The root cause is believed to be the unavailability of a hand truck or pallet jack. Instead of waiting, John attempted carrying the load himself. A second possible cause is the condition of John’s PPE, specifically his boots, which are very worn in certain places.
When John fell, his colleagues rushed to his assistance. Suspecting a fracture, the supervisor on the floor (Kathy Pickens) decided to call 911.
John said he felt a bit dizzy when he lost his balance and that he just ‘tripped over his feet.’ He tried to minimize damage to the load itself while falling, which may have led to a more awkward fall.
Two of his co-workers said that they noticed he was struggling a bit before the fall, but were busy with their own tasks and felt it would be rude to ‘call him out.’ See the attached witness statements for more info.
John was taken to a nearby hospital and a fracture to his wrist was confirmed. John will be out of work for a number of weeks.
The supervisor is currently working with the safety officer (Chris Darnell) to assess the condition of the floor, the number and condition of hand trucks and pallet jacks on the floor, as well as the condition of company-provided boots over two years old.”
Do'stlaringiz bilan baham: |