The diagram shows how to change a flat tyre

The diagram shows how to change a flat tyre.
Overall, it is clear that mechanical process involves 14 steps and is divided into two main stages.
The first part of the process is that there is a lot of glass debris under the road which causes the tires to go faulty . Then, park the auto in a suitable place to pull over the car, turn on the hazard lights and prepare the spare tire, jack, and wrench. The following step is to remove the hub car and loosen the wheel nuts and make sure to not remove it at that time. After that, carefully place the jack under the car near the flat tire about 15cms from the surface of the road.
The other part goes into change the tyre. Before use, the spare tire, make sure to remove the lug nuts. Then remove the flat tyre, push the new onto the place and remember do not to tighten all the way. Before tightening each one halfway and continue until all are tight, use the jack again to low the car. Finally, remember to do not to leave anything on the side of the road.