Страница 1 мировой engineering стандарты общая спецификация

8.10.3 Positive Response Message Definition (Table 116).
Table 116: DynamicallyDefineMessage Positive Response Messages
Data Byte
Parameter Name
Cvt Hex Value Mnemonic
#1
DynamicallyDefineMessage Positive Response Service Id
M
6C
SIDPR
#2
DPIDIdentifier = [
DPID#]
M FE thru 90
or
7F thru 01
PRMN_
DPIDID
8.10.3.1 Positive Response Message Data Parameter Definition (Table 117).
Table 117: DynamicallyDefineMessage Data Parameter Definition
Definition
DPIDIdentifier
The value of the Data Packet contained within the request message. This is an echo of the request
DPIDIdentifier to confirm completion of the DPID assignment.
8.10.4 Supported Negative Response Codes (RC_). 
The following negative response codes (Table 118)
shall be implemented for this service. The circumstances under which each response code would occur are
documented in Table 118.
Page 143
GM WORLDWIDE ENGINEERING STANDARDS
GMW3110
Table 118: Supported Negative Response Codes

---

25.06.2020
WORLDWIDE ENGINEERING STANDARDS General Motors Local Area Network Enhanced Diagnostic Test Mode Specification
https://translate.googleusercontent.com/translate_f
127/298
© Copyright 2010 General Motors All Rights Reserved
February 2010
Page 143 of 336
Hex Description
Cvt Mnemonic
12
SubFunctionNotSupported-InvalidFormat
The length of the request message is such that the request does not contain a
DPID number and at least one PID.
The length of the request message does not contain an even number of bytes
(each PID is a 2-byte value so length must be an even number).
If the total number of data bytes which would be reported in the UUDT message
exceeds seven data bytes.
M
SFNS-IF
31