Страница 1 мировой engineering стандарты общая спецификация

ReservedByDocument
These values are reserved by this document for standardized expansion.
M
Where:
M
1 
= This level is mandatory for all ECUs on the SWCAN link and not applicable to the DWCAN links.
8.17.2.2 Request Message Data Parameter Definition. 
There are no data parameters in a request for this
service.
8.17.3 Positive Response Message Definition (Table 167).
Table 167: ProgrammingMode Positive Response Message
Data Byte Parameter Name
Cvt Hex Value Mnemonic
#1
ProgrammingMode Positive Response Service Id
M
2
E5
SIDPR
Where:
M
2 
= Mandatory if the request message uses a sub-parameter value of $01 or $02. There is no response to a
request message with a sub-parameter value of $03.
Page 188
GM WORLDWIDE ENGINEERING STANDARDS
GMW3110
8.17.3.1 Positive Response Message Data Parameter Definition. 
There are no data parameters in a
response to a request for this service.
8.17.4 Supported Negative Response Codes (RC_). 
The following negative response codes shall be
implemented for this service. See Table 168.
Table 168: Supported Negative Response Codes
Hex Description
Cvt Mnemonic
12
SubFunctionNotSupported-InvalidFormat
This return code shall occur if the sub-parameter is not valid and programming
mode is not already active (if programming mode is active at the time of a
request, the $22 response is sent. See item 4 in the response code $22 section
M
SFNS-IF

---

25.06.2020
WORLDWIDE ENGINEERING STANDARDS General Motors Local Area Network Enhanced Diagnostic Test Mode Specification
https://translate.googleusercontent.com/translate_f
167/298
© Copyright 2010 General Motors All Rights Reserved
February 2010
Page 188 of 336
of this table).
This return code shall occur if the length of the requested message is incorrect.
22