Страница 1 мировой engineering стандарты общая спецификация

8.9.2 Request Message Definition (Table 109).
Table 109: DisableNormalCommunication Request Message
Data Byte
Parameter Name
Cvt Hex Value Mnemonic
#1
DisableNormalCommunication Request Service Id
M
28
SIDRQ
8.9.2.1 Request Message Sub-Function Parameter $Level (LEV_) Definition. 
Because this service is
defined as a single operation, there are no sub-function parameters required or valid for the request message.
8.9.2.2 Request Message Data Parameter Definition. 
There are no data parameters used with this service.
8.9.3 Positive Response Message Definition (Table 110).
Table 110: Disable Normal Communication Positive Response Message
Data Byte
Parameter Name
Cvt Hex Value Mnemonic
#1
DisableNormalCommunication Positive Response Service Id
M
68
SIDPR
8.9.3.1 Response Message Data Parameter Definition. 
There are no data parameters used by this service
in the positive response message.
Page 138
GM WORLDWIDE ENGINEERING STANDARDS
GMW3110
8.9.4 Supported Negative Response Codes (RC_). 
The following negative response codes (Table 111) shall
be implemented for this service. The circumstances under which each response code would occur are
documented in the table below.
Table 111: Supported Negative Response Codes
Hex
Description
Cvt Mnemonic
12
SubFunctionNotSupported-InvalidFormat
Used when the request message contains more than the SID byte.
M
SFNS-IF
22
ConditionsNotCorrectOrRequestSequenceError
Used when the node is in a critical normal mode activity. If this return code is
implemented, the reasons shall be documented in the CTS.
C
CNCRSE