Ksp reference Manual

Engine Parameter Commands
127
KSP Reference Manual

---

14.7. set_engine_par()
set_engine_par(
ter>,ue>,,,ic>)
Control automatable KONTAKT pa-
rameters and bypass buttons
The parameter to be controlled with a built-in variable, e.g. 
$ENGINE_PAR_CUT-
OFF

The value to which the specified parameter is set.
The range of values is always 0 to 1000000, except for switches in which case it is
0 or 1.

The index (zero based) of the group in which the specified parameter resides.
If the specified parameter resides on an 
Instrument
level, enter 
-1
.
Busses also reside on 
Instrument
level, so you need to set to 
-1
if you
want to address a bus.

The slot index (zero based) of the specified parameter. This applies only to group/
instrument effects, modulators and modulation intensities.
For group/instrument effects, this parameter specifies the slot in which the effect
resides (zero-based).
For modulators and modulation intensities, this parameters specifies the index
which you can retrieve by using:
find_mod(,)
For all other applications, set this parameter to 
-1
.

This parameter applies to instrument effects and to internal modulators.
For instrument effects, this parameter distinguishes between: