3.
Adjust the paper-length
guide by squeezing the
adjustment latch and sliding the guides to the
size of the paper being used.
11
B5
A4
3
4.
Load paper into the tray. For information about
how
to orient the paper, see
Tray 3 paper
orientation on page 23
NOTE:
Do not adjust the paper guides tightly
against the paper stack.
Adjust them to the
indentations or markings in the tray.
NOTE:
To prevent jams, adjust the paper guides
to the correct size and do not overfill the tray. Be
sure that the top of
the stack is below the tray
full indicators, as shown in the enlargement in
the illustration.
NOTE:
If the
tray is not adjusted correctly, an
error message might display during printing or
the paper might jam.
3
5.
Slide the tray completely into the printer.
RD
2
1
3
6.
At the computer, begin
the printing process from
the software application. Make sure that the
driver is set to the correct paper type and size for
the paper being printed from the tray.
22
Chapter 2
Paper trays
ENWW
Tray 3 paper orientation
When using paper that requires a specific orientation, load it according to the information in the following
table.
Paper type
Output
How to load paper
Letterhead or preprinted
1-sided printing
Face-up
Top edge
at the front of the tray
2
1
Do'stlaringiz bilan baham: