Hp laserJet Pro M402, M403 User Guide enww

NOTE:
The printer setting must match the setting for the network device (a network hub, switch, gateway, 
router, or computer).
NOTE:
Making changes to these settings causes the printer to turn off and then on. Make changes only 
when the printer is idle.
1.
On the printer control panel, press the 
OK
button.
2.
Open the following menus:
60
Chapter 5 Manage the printer
ENWW

---

●
Network Setup
●
Link Speed
3.
Select one of the following options:
●
Automatic: The print server automatically configures itself for the highest link speed and 
communication mode allowed on the network.
●
10T Full: 10 megabytes per second (Mbps), full-duplex operation
●
10T Half: 10 Mbps, half-duplex operation
●
100TX Full: 100 Mbps, full-duplex operation
●
100TX Half: 100 Mbps, half-duplex operation
●
1000T Full: 1000 Mbps, full-duplex operation
4.
Press the 
OK
button. The printer turns off and then on.
ENWW
Configure IP network settings
61

---

Printer security features
Introduction
The printer includes several security features to restrict who has access to configuration settings, to secure 
data, and to prevent access to valuable hardware components.
●
Assign or change the system password using the HP Embedded Web Server
●
Lock the formatter
Assign or change the system password using the HP Embedded Web Server
Assign an administrator password for access to the printer and the HP Embedded Web Server so that 
unauthorized users cannot change the printer settings.