Ccna routing and Switching Complete Study Guide

Access List Configurations

To configure a standard named access list, you’ll need to get to the prompt 

Switch(config-std-nacl)#

:

Switch#

config t

Switch(config)#

ip access-list standard Todd

Switch(config-std-nacl)#

What you see here is a typical basic standard ACL prompt. There are various ways to con-

figure access lists, and the prompts are only slightly different from this particular example.

Routing Protocol Configurations

I need to point out that we don’t use routing or router protocols on 2960 switches, but we 

can and will use them on my 3560 switches. Here is an example of configuring routing on a 

layer 3 switch:

---

Command-Line Interface (CLI) 

213

Switch(config)#

router rip

IP routing not enabled

Switch(config)#