Basic Configuration Commands Table of Contents

Default value

N/A

Command mode

the EXEC mode or the configuration mode

Explanation

This command can be used to filter the useless information in the result of the show command, especially when the result is too much to read. For example, if you want to browse a designated MAC address in an MAC address table, which contains a lot of MAC addresses, this command will give you convenience for you.

Example

The following example shows how to display the lines, in which the word “interface” is contained, in the result of show running-config.
Switch#show running-config | include interface
Building configuration...

Current configuration:

!
interface GigaEthernet0/1
interface GigaEthernet0/2
interface GigaEthernet0/3
interface GigaEthernet0/4
interface GigaEthernet0/5
interface GigaEthernet0/6
interface GigaEthernet0/7
interface GigaEthernet0/8

Related command

N/A

1.2.17 show job

It is used to display the parameters of the job and the information about job execution:
show job {paramter | status}

Parameter

Parameter	Description
paramter	Displays the parameters of the job.
status	Displays the execution state of the job.

Default

None

Command mode

Management mode or configuration mode

Instruction

Run the show job command to browse the defined parameters and the dynamic execution state of the job.