Word logic operations

The enable output ENO is reset if one of the following conditions applies:

• 
  Enable input EN has the signal state "0".
  
• 
  The value of the K parameter is greater than the number of available outputs.
  
• 
  Errors occurred during execution of the instruction.
  

Parameters

The following table shows the parameters of the instruction "Demultiplex":



You can select the data type of the instruction from the "" drop-down list of the instruction box.

For additional information on available data types, refer to "See also".

Example

The following example shows how the instruction works:

The following tables show how the instruction works using specific operand values:

Input values of the "Demultiplex" instruction before network execution



Output values of the "Demultiplex" instruction after network execution



If the "Tag_Input" input has the signal state"1", the "Demultiplex" instruction is executed. Depending on the value of the operand "Tag_Number", the value at input "IN" is copied to the corresponding output.