Wimax standards and Security The Wimax

SUT Configuration 1

Figure 9.2 shows the SUT test configuration. The BS transmits broadcast messages while the monitoring device captures all the necessary MAC and PHY/RF parameters. The BS is connected to a test generating equip- ment/packet generator/controller via a local area network.

2. 
   SUT Configuration 2
   

The test configuration 2 is shown in Figure 9.3. The BS transmits and receives data packets from a single SS while a monitoring device captures all the necessary MAC messages and PHY/RF parameters.

3. 
   SUT Configuration 3
   

In this test configuration, shown in Figure 9.4, the BS transmits and receives data packets from two SSs (SS1 and SS2) while a monitoring device captures all the necessary MAC messages and PHY/RF parameters. SS1 and BS vendors are different, while SS2 may be from the same vendor as the BS.





FIGURE 9.2
Setup for SUT1.





FIGURE 9.3
Setup for SUT2.





FIGURE 9.4
Setup for SUT3.





FIGURE 9.5
Setup for SUT4.

4. 
   SUT Configuration 4
   

Figure 9.5 shows the SUT test configuration 4. In this configuration, the BS is transmitting and receiving data packets from three SSs (SS1, SS2, and SS3) from three different vendors, while a monitoring device is capturing all the necessary MAC messages and PHY/RF parameters. SS1, SS3, and BS belong to different vendors while SS2 may be from the same vendor as the BS.

5.