Study of Cables in the Distribution System: Parameters Calculation, Fault Analysis, and Configuration Optimization

IEEE Trans. Power 
Deliv.
, vol. 18, no. 3, pp. 667–678, 2003. 
[17] J. C. Kansog, “Ampacity Calculations for Mixed Underground Cable Systems in 
the same Ductbank,” 
IEEE Power Energy Soc. Transm. Distrib. Conf.
, pp. 535–
543, 1994. 
[18] F. Aras, C. Oysu, and G. Yilmaz, “An assessment of the methods for calculating 
ampacity of underground power cables,” 
Electr. Power Components Syst.
, vol. 33, 
no. 12, pp. 1385–1402, 2005. 
[19] A. Y. Klestoff, “Current-Carrying Capability for Industrial Underground Cable 
Installations,” 
IEEE Trans. Ind. Appl.
, vol. 24, no. 1, pp. 99–105, 1988. 
[20] J.H.Neher and M.H.McGrath, “The calculation of the temperature rise and load 
capability of cable systems,” 
AIEE Trans.
, vol. 76, pp. 752–772, 1957. 
[21] IEC, 
Calculation of the current rating of cables
. IEC Standard Publication 60287-
3-2, 2012. 
[22] W. Moutassem and G. J. Anders, “Configuration optimization of underground 
cables for best ampacity,” 
IEEE Trans. Power Deliv.
, vol. 25, no. 4, pp. 2037–
2045, 2010. 
[23] W. Moutassem, “Optimization procedure for rating calculations of unequally 
loaded power cables.” M.S. Thesis, Univ. Toronto, Toronto, ON, Canada, 2007. 
[24] K.W.Burkes, “Water tree analysis and on-line detection algorithm using time 
domain reflectometry.” M.S. Thesis, Dept. Elect. Comput. Eng., Clemson Univ., 
2014. 

---

140 
[25] E. F. Steennis and F. H. Kreuger, “Water Treeing in Polyethylene Cables,” 
IEEE 
Trans. Electr. Insul.
, vol. 25, no. 5, pp. 989–1028, 1990. 
[26] M. R. Iravani, A. K. S. Chaudhary, W. J. Giesbrecht, I. E. Hassan, A. J. F. Keri, K. 
C. Lee, J. A. Martinez, A. S. Morched, B. A. Mork, M. Parniani, A. Sharshar, D. 
Shirmohammadi, R. A. Walling, and D. A. Woodford, “Modeling and analysis 
guidelines for slow transients - Part III: the study of ferroresonance,” 
IEEE Trans. 
Power Deliv.
, vol. 15, no. 1, pp. 255–265, 2000. 
[27] B. Bátora and P. Toman, “Using of PSCAD Software for Simulation 
Ferroresonance Phenomenon in the Power System with the Three-phase Power 
Transformer,” 
Trans. Electr. Eng.
, vol. 2, no. 4, pp. 102–105, 2013. 
[28] S. Hay and A. Ferguson, “A Review of Power System Modelling Platforms and 
Capabilities,” 
IET Spec. Interes. Publ. Counc. Sci. Technol.
, no. March, pp. 3–13, 
2015. 
[29] PSCAD Company, “EMTDC User Guide,” 2001. 
[30] Jean Carlos Hernández Mejía, “Characterization of Real Power Cable Defects By 
Diagnostic Measurements,” Ph.D. Dissertation, Georgia Institute of Technology, 
December, 2008. 
[31] S. N. T. Ozaki, N.Ito, I. Sengoku, J.Kawai, “Changes of capacitance and dielectric 
dissipation factor of water-treed xlpe with voltage,” 
Proc. Int. Symp. Elect. Insul. 
Mater.(ISEIM)
, pp. 459–462, 2001. 
[32] J. Kawai and S. E. Wire, “Relative Permittivity and Conductivity of Water-treed 
Region in Cross-linked Polyethylene,” 
Proc. IEEE 7th Int. Conf. Solid 

---

141 
Dielectr.(ICSD)
, pp. 163–166, 2001. 
[33] Y. Z. Arief, M. Shafanizam, Z. Adzis, and M. Z. H. Makmud, “Degradation of 
polymeric power cable due to water treeing under AC and DC stress,” 
PECon 
2012 - 2012 IEEE Int. Conf. Power Energy
, December, pp. 950–955, 2012. 
[34] Cadence Spice, “https://www.cadence.com/content/cadence-
www/global/en_US/home.html.” . 
[35] COMSOL Multiphysics, “https://www.comsol.com/.” . 
[36] AC/DC Module of COMSOL, “https://www.comsol.com/acdc-module”. 
[37] Johan J. Grainger; William D. Stevenson,