Страница 1 мировой engineering стандарты общая спецификация

Procedure 3: 
(if sub-function $03 is supported).
1. Send a $10 message with $level = $03 and then activate a device control. Send TesterPresent messages
for a time greater than P3
Cmax 
(but less than any device control restriction timer) and then create a failure
which would set a DTC. Verify that the DTC is set via the $A9 service (undo the failure condition created
and clear DTCs prior to proceeding to step 2 of this procedure).
2. Send a $10 message with $Level = $03 and then activate a device control. Next send a $10 message with
$level = $02. Create a failure which would set a DTC and then verify that no DTC is set.
3. Send a $10 message with $Level = $03 while device control is already active and verify the negative
response ($7F $10 $22).
4. Send a service $28 message on the link and verify the positive response. Then send a $10 request with
$Level = $03 and verify the negative response ($7F $10 $22).
Procedure 4: 
(if sub-function $04 is supported).
1. Send a $10 request with $Level = $04 and verify that the device performs the appropriate wake-up
mechanism on all GMLAN subnets that it is connected to that support a wake-up.
2. If the wake-up mechanism on any GMLAN link requires continuous activation to keep the ECUs awake
(e.g., gateway provides power through a relay to ECUs on a specific subnet), then send messages to the
gateway to keep the gateways diagnostic VN active. Periodically check that the tester can communicate to
other ECUs on the subnet via diagnostic services. This test should be performed under conditions where
the ECU would otherwise let the link go down if the diagnostic VN were not active. Allow the diagnostic VN
to end, and then verify that communications with other ECUs is no longer possible.
--``,,``````,``,,``,,,`,`,`,,-`-`,,`,,`,`,,`---
Page 83
GM WORLDWIDE ENGINEERING STANDARDS