Страница 1 мировой engineering стандарты общая спецификация

Procedure 2:
1. Disable normal communication then send a requestProgrammingMode_HighSpeed message ($A5 $02)
with extra data bytes. Verify the negative response ($7F $A5 $12) message.
2. Send a requestProgrammingMode_HighSpeed message ($A5 $02) without disabling normal
communication. Verify the negative response ($7F $A5 $22) message.
3. If applicable, create conditions under which the node should not allow a programming event to take place
in high speed mode. Then send a requestProgrammingMode_HighSpeed message ($A5 $02). Verify the
negative response ($7F $A5 $22) message.
4. Disable normal communication, send a requestProgrammingMode_HighSpeed message ($A5 $02). Verify
the positive response ($E5) message. Send a ReturnToNormalMode ($20) request message and verify
the positive response. Then send a request to enableProgrammingMode ($03) and verify the negative
response ($7F $A5 $22) message.
5. Disable normal communication, send a requestProgrammingMode_HighSpeed message ($A5 $02). Verify
the positive response ($E5) message. Allow a P3
C 
timeout to occur and then send a request to
enableProgrammingMode ($03) and verify the negative response ($7F $A5 $22) message.
6. Repeat steps 1 and 2 of Procedure 1 above (for high speed devices). Then send a request for this service
with a supported sub-parameter. Verify the proper negative response (7F $A5 $22) and that there is no
impact to the current programming event. Repeat this procedure for each supported sub-parameter of this
service. In addition, verify that the device remains in high speed operation.
Procedure 3:
1. Disable normal communication, then send a requestProgrammingMode_HighSpeed message ($A5 $02).
After receiving responses from all ECUs, send a requestProgrammingMode message ($A5 $01) when
conditions are correct to begin a low speed programming event. Verify positive responses from all ECUs to
the requestProgrammingMode request. Next send an enableProgrammingMode ($A5 $03) request. Verify
no responses are sent to the enableProgrammingMode request and then verify that the ECU stayed in low
speed operation by requesting an additional diagnostic service.

---

25.06.2020
WORLDWIDE ENGINEERING STANDARDS General Motors Local Area Network Enhanced Diagnostic Test Mode Specification
https://translate.googleusercontent.com/translate_f
172/298
--``,,``````,``,,``,,,`,`,`,,-`-`,,`,,`,`,,`---