Laboratory work 7 The purpose of the work

7. Disconnect the block
To disconnect the block from the connecting lines With the key pressed push it somewhere else.


8. Turn the block
Follow these steps to turn the block:

• 
  _{turn need which was block separation ng ;}
  
• 
  _{block scheme of the window In} the Format menu following from commands one of them select g : Flir Block ( Block 180 gradu ­sga turn ) or Rotate Block _ hour arrow in the direction of 90 degrees turn ).
  

9. Resize the block


Detach the block and move the mouse pointer over one of the block corner icons. When the shape of the pointer changes to the appearance of an arrow pointing in both directions, press the left mouse button and move it in the desired direction.


10. Rename and push the block
The name of the block must be unique and consist of at least one character. To change the name of the block, release the left mouse button on it and make the necessary changes using the usual methods .
To change the font, call the Font command from the Format menu in the model window and select the font from the dialog box that opens . If the direction of the signal passing through the block is from left to right, the name of the block is below it, if the direction of the signal is from right to left, it is above, and if it is from bottom to top, or from top to bottom, the block is on the right. .
Allocated block of the name o ' rnini two kind of method with change ng :

• 
  push with the mouse to the opposite side of the block;
  
• 
  Format menu of the model window Using the Flir Name command - this method also allows you to move the block name in the opposite direction.
  

Name in the Format menu of the model window to hide the block name close ) command use ng . Blocking closed name restore for Show Name _ _ show ) command . _