Laboratory work 7 The purpose of the work

3. Actions with blocks
To place copies of blocks in one window in the other window, do the following: open the window of the desired library or model-prototype and drag the desired block to the window of the model being created (edited) with the mouse.
Copy from blocks using menu commands. Bunda executable actions in series as follows will be :

• 
  ^{model or biblioteka in the window copy to be taken need which was block or blocks ni marked g} ;
  
• 
  active of the window In the Edit menu _ _ Question ( Copy take ) command select g ;
  
• 
  _{blocking copy removable _ oyna ni activation ng and in it From the} Edit menu Rast command select g .
  

4. Replacement of model blocks
Replace the blocks inside the model by pushing them with the mouse. In doing so, Simulink redraws the lines connecting the blocks. To push several blocks together, separate them and move one of the separated blocks to a new position. The remaining separated blocks are also pushed without changing the relative distances and connecting lines between them.

5. Copy the blocks within the model using the following two methods:

• 
  Press to move the block to the desired location;
  
• 
  _{right-click and} drag to the desired location, where the block will be assigned the next sequence number .
  

6. Remove the block.
To remove unnecessary blocks in a block diagram, separate them by or Press one of the keys. Also of the block diagram window You can also use the Clear or Cut commands in the Edit menu . If the Cut command is used, a copy of the removed block can then be placed on the model using the Raste command.