Interfaces
.
2.
Double-click
VPN Server
.
3.
In the
VPN Server Properties
dialog, check
Enable Kerio VPN Server
.
4.
On tab
Kerio VPN
, select a valid certificate.
5.
The port
4090
is set as default. Both TCP and UDP protocols are used.
NOTES
Do not switch to another port without a proper reason.
If it is not possible to run the VPN Server on the specified port, the error is reported in the
Error log
.
6.
To specify a VPN route manually, read section
Configuring routing
.
7.
Kerio VPN Server directs the traffic from VPN clients in two ways:
Only traffic which ends in the Kerio Control network goes through the firewall — default mode. This type of
connection is called split tunneling.
All traffic goes through the firewall — select
Do'stlaringiz bilan baham: |