Ccna routing and Switching Complete Study Guide

A.  There are very few collisions in full-duplex mode.

B.  A dedicated switch port is required for each full-duplex node.

C.  The host network card and the switch port must be capable of operating in full-duplex 

mode to use full-duplex.

D.  The default behavior of 10Base-T and 100Base-T hosts is 10 Mbps half-duplex if the 

autodetect mechanism fails.

15.  In the following diagram, identify the cable types required for connections A and B.

Switch

A

Switch

B

B

A.  A= crossover, B= crossover

B.  A= crossover, B= straight-through

C.  A= straight-through, B= straight-through

D.  A= straight-through, B= crossover

---

Review Questions 

83

16.  In the following image, match the cable type to the standard with which it goes.

IEEE 802.3u

IEEE 802.3

IEEE 802.3ab

IEEE 802.3z

1000Base-T

1000Base-SX

10Base-T

100Base-TX

17.  The cable used to connect to the console port on a router or switch is called a 

  cable.