Ccna certification Practice Tests

A.  The Gig 0/1 interface on es-switch2

B.  The Gig 0/1 interface on cs-main.ntw

C.  The Gig 0/1 interface on es-layer2.ntw

D.  The Gig 0/1 interface on es-switch3.ntw

 29.  You check the status of the EtherChannel configured on the switch with the  

show etherchannel command. What can be concluded from the output? Refer to  

the exhibit below.

Group state = L2

Ports: 2 Maxports = 8

Port-channels: 1 Max Port-channels = 1

Protocol:     -

SwitchA#

Group: 1

Channel-group listing:

SwitchA#sh etherchannel

A.  The EtherChannel is configured with PAgP.

B.  The EtherChannel is configured with LACP.

C.  The EtherChannel is configured with no control protocol.

D.  The EtherChannel is configured as an access port.

---

220

 

Chapter 7 

■

  Practice Exam 1

 30.  You are configuring an EtherChannel between two switches. You check your 

configuration on the first switch and are ready to configure the second switch. What mode 

do you need to configure on the other switch? Refer to the following exhibit.

SwitchA#sh run

Building configuration...

[output cut]

!

interface Port-channel 1

!

[output cut]

interface GigabitEthernet0/1

 channel-group 1 mode auto

!

interface GigabitEthernet0/2

 channel-group 1 mode auto

[output cut]

A. 

Switch(config-if)#channel-group 1 mode auto

B. 

Switch(config-if)#channel-group 1 mode desirable

C. 

Switch(config-if)#channel-group 1 mode active

D. 

Switch(config-if)#channel-group 1 mode passive

 31.  You are configuring an EtherChannel between two switches for trunking. The 

EtherChannel will not form. You check your configuration on the first switch. What is the 

problem on the other switch? Refer to the following exhibit.

SwitchA#sh run

Building configuration...

[output cut]

!

interface Port-channel 1

!

[output cut]

interface GigabitEthernet0/1

 channel-group 1 mode passive

!

interface GigabitEthernet0/2

 channel-group 1 mode passive

[output cut]