Configuring a Manual Layer 2 EtherChannel
To configure a Layer 2 EtherChannel so that all the ports always attempt to be part of the
channel, simply add the correct channel-group configuration command to each physical
interface, on each switch, all with the on keyword, and all with the same number. The on
keyword tells the switches to place a physical interface into an EtherChannel, and the num-
ber identifies the PortChannel interface number that the interface should be a part of.
Before getting into the configuration and verification, however, you need to start using
three terms as synonyms: EtherChannel, PortChannel, and Channel-group. Oddly, IOS
uses the channel-group configuration command, but then to display its status, IOS uses the
Do'stlaringiz bilan baham: |