A anycast address B. global unicast address C. multicast address D

Correct Answer: B
76 Refer to the exhibit.

An access list is created to deny Telnet access from host PC-1 to RTR-1 and allow access from all other hosts A Telnet attempt from PC-2 gives this message:"% Connection refused by remote host" Without allowing Telnet access from PC-1, which action must be taken to permit the traffic?
A. Add the ip access-group 10 out command to interface g0/0.
B. Add the access-list 10 permit any command to the configuration
C. Remove the access-class 10 in command from line vty 0.4.
D. Remove the password command from line vty 0 4.
Correct Answer: B
77 A network engineer is replacing the switches that belong to a managed-services client with new Cisco Catalyst switches. The new switches will be configured for updated security standards, including replacing Telnet services with encrypted connections and doubling the modulus size from 1024. Which two commands must the engineer configure on the new switches? (Choose two.)
A. transport input all
B. crypto key generate rsa usage-keys
C. crypto key generate rsa general-keys modulus 1024
D. crypto key generate rsa modulus 2048
E. transport Input ssh
Correct Answer: D,E
78 What are network endpoints?
A. support inter-VLAN connectivity
B. enforce policies for campus-wide traffic going to the internet
C. a threat to the network if they are compromised
D. act as routers to connect a user to the service prowler network
Correct Answer: C
79 Two switches are connected and using Cisco Dynamic Trunking Protocol SW1 is set to Dynamic Desirable What is the result of this configuration?
A. The link becomes a trunk port.
B. The link is in an error disables state
C. The link is in a down state.
D. The link is becomes an access port.
Correct Answer: A

80 DRAG DROP -

Drag and drop the functions of SNMP fault-management from the left onto the definitions on the right.
Select and Place:

Correct Answer: